Decayer · settings for Squier Stratocaster + Marshall DSL40CR
At zero: Gain · Volume · Reverb
No effects needed for this part.
Ultra Gain channel in OD2 for maximum saturation, tight bass and firm presence on the DSL40CR. The Squier's low-output single-coils need extra gain and a tight right hand to approach a modern gated deathcore chug.
Low end stays looser and pick attack is softer than the tight modern chug.
Workaround: Keep bass at 5, presence up, and palm-mute hard right at the bridge for attack.
Single-coil hum and amp hiss fill the silence between breakdown hits.
Workaround: Mute strings with the fretting hand and palm immediately after each stab; angle away from the amp to reduce hum.
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker (active-style output typical of the genre)
Guitar → Tube Screamer-style boost → Noise gate → High-gain amp / amp sim → 4x12 cabinet (mic'd or impulse response)
Technically approachable riffs, but the tone depends on very tight right-hand muting and gating rather than difficult fretting.
Every song already dialed in for the Marshall DSL40CR.
Marshall DSL40CR settings