Decayer · settings for Squier Stratocaster + Marshall JCM800 2203
No effects needed for this part.
A Squier Strat into a JCM800 can't reach modern deathcore saturation, but the High input with the preamp cranked gets an aggressive, tight 80s high-gain riff tone. Expect more hum and less low-end weight without a boost or gate.
Without it the JCM800 stays loose and mid-light under low-output pickups; chugs lose tightness and gain.
Workaround: Max the preamp on the High input, dial bass back slightly if flubby, and rely on hard palm-muting for attack.
Cranked JCM800 plus single-coils hums loudly; stabs and breakdown gaps won't be silent.
Workaround: Mute with the picking-hand palm and left-hand fingers between hits; turn away from fluorescent lights and screens.
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker (active-style output typical of the genre)
Guitar → Tube Screamer-style boost → Noise gate → High-gain amp / amp sim → 4x12 cabinet (mic'd or impulse response)
Technically approachable riffs, but the tone depends on very tight right-hand muting and gating rather than difficult fretting.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings