Metallica · settings for Epiphone Les Paul Standard + Fender '65 Twin Reverb Reissue
At zero: Bright switch · Reverb · Tremolo Speed · Tremolo Intensity
No effects needed for this part.
A Twin Reverb with ProBuckers cannot reach Mark IIC++ saturation, so this is a loud, edge-of-clean approximation: bridge pickup, scooped mids, bright off, reverb and tremolo off, volume pushed for the only grit available.
No 1.2kHz notch, so the rhythm tone lacks the signature scoop and sounds boxier.
Workaround: Approximate with Middle at 2 and rolling the bridge tone to 7-8.
Chugs are less even and layered-sounding than the record.
Workaround: Use very consistent downpicking depth and pressure to even out dynamics manually.
Gaps between chugs ring and hum instead of being silent.
Workaround: Mute with the picking-hand palm and fretting-hand fingers between stabs.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge (EMG 81)
ESP MX-220 (EMG 81 bridge) → Mesa/Boogie Mark IIC++ preamp → FX loop: Aphex EQF-2 EQs + Aphex CX-1 compressor → Mark IIC++ power amp → 4x12 cabinet (multi-mic'd) → Layered Marshall head + 4x12 for midrange → Jerry Jones baritone layer on the main riff
The notes are simple power chords, but the feel depends on perfectly even downpicked muting and locked-in timing at a slow, exposed tempo.
Every song already dialed in for the Fender '65 Twin Reverb Reissue.
Fender '65 Twin Reverb Reissue settings