Metallica · settings for Epiphone Les Paul Standard + Marshall DSL40CR
At zero: Gain · Volume · Reverb
No effects needed for this part.
Ultra Gain OD1 on the DSL40CR with a scooped-mid Marshall take on the Mesa Mark IIC++ rhythm tone: bridge ProBucker, tight bass, low mids, firm presence, no reverb. Tune to D standard and downpick hard.
Without the 1.2kHz notch the tone is more Marshall-honky than the Mesa scoop.
Workaround: Use the amp's Tone Shift button and keep Middle near 3 to approximate the scoop.
High-gain chugs ring and hiss between stabs instead of snapping silent.
Workaround: Mute with the picking-hand palm and fretting-hand fingers right after each chug.
Slightly less even attack across layered chugs.
Workaround: Keep downpicking dynamics very consistent; the DSL's power section compresses at higher master.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge (EMG 81)
ESP MX-220 (EMG 81 bridge) → Mesa/Boogie Mark IIC++ preamp → FX loop: Aphex EQF-2 EQs + Aphex CX-1 compressor → Mark IIC++ power amp → 4x12 cabinet (multi-mic'd) → Layered Marshall head + 4x12 for midrange → Jerry Jones baritone layer on the main riff
The notes are simple power chords, but the feel depends on perfectly even downpicked muting and locked-in timing at a slow, exposed tempo.
Every song already dialed in for the Marshall DSL40CR.
Marshall DSL40CR settings