Ozzy Osbourne · settings for Epiphone Les Paul Standard + Yamaha THR10II
Slow rate, shallow depth.
Small room.
Randy's S.A.T.O. riff on a THR10II: Crunch mode pushed with the Les Paul bridge humbucker, mids forward, bright treble, tight low end, and a tiny chorus for the studio double-tracked width.
Less mid-forward bite and front-end push than the hard-clipped Marshall sound
Workaround: Raise Crunch gain to 7 and Middle to 8 to emulate the mid hump
Less precise 1kHz presence shaping and boost
Workaround: Middle at 8 and Treble 7 approximate the 1-2kHz lift
No filter sweep available for the climax
Workaround: Use tone knob rolls for a partial filter effect
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker
Gibson Les Paul Custom / polka-dot Flying V (bridge pickup) → Dunlop Cry Baby Wah → MXR Distortion + → MXR Ten Band Graphic EQ → Marshall JMP 1959 Super Lead 100W (Variac) → Marshall 1960A 4x12 with Altec 417-8H → AMS DMX 15-80S delay/detune (console)
The riff is not harmonically hard, but the relentless palm-muted tempo and quick power-chord moves demand clean, even picking and stamina.