The Cult · settings for Epiphone Les Paul Standard + Fender Mustang LT25
Low-moderate feedback/resonance, mix ~40%.
~400 ms, feedback 3 repeats, mix ~30%, tap to song tempo.
Small room/spring, mix ~15%.
Clean Fender model with slight edge, bridge humbucker split for chime, built-in flanger plus delay to approximate the Boss chain. The single delay block cannot stack the two DM-2s, and chorus and flanger can't both run.
Loses the dual-delay wash of stacked 400 and 800 ms repeats.
Workaround: Raise delay feedback slightly and use a dotted-feel time so repeats overlap more.
Chorus shimmer missing while the flanger block occupies modulation.
Workaround: Use flanger with low feedback and slow rate for a chorus-like sweep.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge (estimated; not documented)
Gretsch White Falcon → Ibanez TS808 Tube Screamer → MXR Phase 100 → Boss BF-2 Flanger → Boss DM-2 Analog Delay (short) → Boss DM-2 Analog Delay (long) → Roland JC-120 Jazz Chorus → Roland JC-120 internal 2x12 combo speakers
Amp effects: chorus (JC-120 built-in stereo chorus; Duffy calls it 'unbeatable' and his go-to clean sound)
Easy to finger; the challenge is keeping the picking even so the stacked delays stay rhythmic rather than muddy.
Every song already dialed in for the Fender Mustang LT25.
Fender Mustang LT25 settings