The Cult · settings for Epiphone Les Paul Standard + Positive Grid Spark 40
Tube-screamer style model: drive 2, tone 6, level 6.
Flanger: rate 25%, depth 60%, feedback 40%, mix 50%.
Room or plate, decay short, mix 15%.
Bright edge-of-breakup clean on the Spark's Clean voicing with the Roland JC-120 model, chorus or flanger from the mod block and one dotted-style delay. The Les Paul's bridge humbucker, coil-split if possible, gets close to the Filter'Tron chime.
Loses the stacked-delay wash of two times against each other.
Workaround: Raise the Spark delay feedback to 45% and reverb slightly to thicken the wash.
Can't run chorus and flanger together in one mod slot.
Workaround: Use flanger for the intro feel and switch the mod block to chorus for a lusher riff preset.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge (estimated; not documented)
Gretsch White Falcon → Ibanez TS808 Tube Screamer → MXR Phase 100 → Boss BF-2 Flanger → Boss DM-2 Analog Delay (short) → Boss DM-2 Analog Delay (long) → Roland JC-120 Jazz Chorus → Roland JC-120 internal 2x12 combo speakers
Amp effects: chorus (JC-120 built-in stereo chorus; Duffy calls it 'unbeatable' and his go-to clean sound)
Easy to finger; the challenge is keeping the picking even so the stacked delays stay rhythmic rather than muddy.
Every song already dialed in for the Positive Grid Spark 40.
Positive Grid Spark 40 settings