Pink Floyd · settings for Squier Stratocaster + Blackstar ID:Core 20 V3
2-3 repeats, level low (around 25%).
Small amount, roughly 15-20%.
Gilmour's second solo: neck pickup, near-clean Blackstar Crunch voice at edge-of-breakup, ISF mid-scooped toward American/Hiwatt, built-in delay for trailing repeats. Low-output ceramic Squier pickups need a touch more gain and a tamed treble.
Less sustain and compression on long bends; grit comes from the amp voice instead
Workaround: Use Crunch mode at gain 4 and push with pick attack; roll guitar volume back for quieter entries
Bends decay sooner without even sustain
Workaround: Support notes with wide steady vibrato and pick slightly harder on sustained bends
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Neck (bridge for the third/heavier solo)
1969 Fender Stratocaster "Black Strat" (neck pickup) → MXR Dyna Comp → Colorsound Power Boost → MXR Phase 90 → Binson Echorec → Hiwatt DR103 Custom 100 → WEM Super Starfinder 200 4x12 (Fane Crescendo)
Amp effects: rotary (A Leslie 147 on slow speed is reported alongside the Hiwatt for the drone/swirl texture, not for the clean solo.)
The notes are few and slow, but intonation on long bends, vibrato width and patient phrasing make it hard to sound convincing.
Every song already dialed in for the Blackstar ID:Core 20 V3.
Blackstar ID:Core 20 V3 settings