Pink Floyd · settings for Squier Stratocaster + Marshall JCM800 2203
No effects needed for this part.
Gilmour's second-solo tone: Strat neck pickup, big clean-to-edge-of-breakup. The JCM800 is darker and grittier than a Hiwatt, so use the Low input, modest preamp and open mids for a singing, barely-breaking-up lead voice.
Without it you lose the sustain and level push that makes the long bends sing.
Workaround: Raise preamp to 6-6.5 and dig in harder; use guitar volume for clean-up.
Bends lose the trailing ambient repeats that fill the sparse arrangement.
Workaround: Play into a reverberant room and let notes ring full value.
Slightly less even sustain across long held bends.
Workaround: Pick consistently and use vibrato to sustain rather than attack.
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Neck (bridge for the third/heavier solo)
1969 Fender Stratocaster "Black Strat" (neck pickup) → MXR Dyna Comp → Colorsound Power Boost → MXR Phase 90 → Binson Echorec → Hiwatt DR103 Custom 100 → WEM Super Starfinder 200 4x12 (Fane Crescendo)
Amp effects: rotary (A Leslie 147 on slow speed is reported alongside the Hiwatt for the drone/swirl texture, not for the clean solo.)
The notes are few and slow, but intonation on long bends, vibrato width and patient phrasing make it hard to sound convincing.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings