Slipknot · settings for Epiphone Les Paul Standard + Marshall DSL40CR
At zero: Gain · Volume · Reverb
No effects needed for this part.
Ultra Gain channel in OD2 for the tight high-gain chug, bridge ProBucker full up. Marshall mids are more forward than the Rivera, so pull middle back and push presence/treble for the modern scooped-but-present attack. No gate means careful palm-mute control.
High gain hum between chugs and sloppy riff stops instead of dead silence.
Workaround: Mute with the picking-hand palm and fretting-hand fingers on every rest; back gain to 6.5 and roll guitar volume down between phrases.
Cannot push the 40W power section hard at bedroom volume, so the tone is slightly less compressed.
Workaround: Keep master around 3-4 and lean on the Ultra channel's preamp gain for saturation.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker (active/high-output)
Ibanez MTM1 (bridge Blackout) → Noise gate → Rivera KR7 head → Rivera RockCrusher attenuator → Rivera Silent Sister iso cab with Celestion G12K-100
The notes are simple power chords and single-string chugs, but the groove only works with strict right-hand muting, even attack and a gate-tight tone.
Every song already dialed in for the Marshall DSL40CR.
Marshall DSL40CR settings