Slipknot · settings for Epiphone Les Paul Standard + Marshall JCM800 2203
No effects needed for this part.
JCM800 on the High input with the pre-amp maxed gets close to the KR7's tight chug, but ProBuckers are lower output than Blackouts. Bridge pickup, volume and tone full, scooped-but-present mids, bright top, no reverb. Master as loud as allowed.
Maxed preamp hum and string noise blur the gaps between chugs.
Workaround: Mute with the palm and fretting hand on every rest; roll back guitar volume between phrases.
Without attenuation the 100W amp must be very loud to reach the recorded saturation.
Workaround: Run master as high as the room permits; accept slightly less power-amp compression at lower volume.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker (active/high-output)
Ibanez MTM1 (bridge Blackout) → Noise gate → Rivera KR7 head → Rivera RockCrusher attenuator → Rivera Silent Sister iso cab with Celestion G12K-100
The notes are simple power chords and single-string chugs, but the groove only works with strict right-hand muting, even attack and a gate-tight tone.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings