Avenged Sevenfold · settings for Squier Stratocaster + Fender '65 Twin Reverb Reissue
At zero: Bright switch · Tremolo Speed · Tremolo Intensity
A clean Twin Reverb and low-output single-coils cannot reach Gates' JP-2C high-gain lead. Dial a loud, mid-focused edge-of-breakup clean, bridge pickup, and lean on technique; a distortion pedal is the one essential purchase.
Once you add a distortion pedal, single-coil hum and hiss will swamp phrase gaps.
Workaround: Mute with the picking-hand palm and roll the volume knob down between phrases.
Lead loses the roughly 400 ms trails that thicken the harmony lines.
Workaround: Lean on the amp reverb and let notes ring into each other with legato phrasing.
No extra push into the front end, so sustain and solo lift are reduced.
Workaround: Run amp volume higher and pick harder at the start of each phrase.
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker (Seymour Duncan Invader); Sustainiac neck for sustained bends
Schecter Synyster Gates Custom → MXR Boost/Line Driver → Noise gate → Mesa/Boogie JP-2C head → Delay (mix/effects loop) → Mesa 4x12 with V30s
Gates' lead combines shred-level legato and sweep ideas with melodic harmony lines that need precise timing and vibrato to sit against the second guitar.
Every song already dialed in for the Fender '65 Twin Reverb Reissue.
Fender '65 Twin Reverb Reissue settings