Avenged Sevenfold · settings for Squier Stratocaster + Marshall JCM800 2203
No effects needed for this part.
A JCM800 through low-output single-coils won't reach JP-2C tightness, but a cranked High input with mid-forward EQ gets a singing, midrange lead voice. Bridge pickup, volume full, tone rolled slightly back to tame ceramic brightness.
Single-coils plus maxed preamp will hum and squeal badly between phrases.
Workaround: Mute with the picking-hand palm and left-hand fingers between phrases; angle away from the amp to kill 60-cycle hum.
Legato and harmony lines lose the spatial trail behind them.
Workaround: Let notes ring longer and use wider vibrato to fake sustain and depth.
Less front-end saturation and solo lift; tone stays looser than the original.
Workaround: Run the preamp near max and pick harder into the High input for the lift.
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker (Seymour Duncan Invader); Sustainiac neck for sustained bends
Schecter Synyster Gates Custom → MXR Boost/Line Driver → Noise gate → Mesa/Boogie JP-2C head → Delay (mix/effects loop) → Mesa 4x12 with V30s
Gates' lead combines shred-level legato and sweep ideas with melodic harmony lines that need precise timing and vibrato to sit against the second guitar.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings