Pantera · settings for Epiphone Les Paul Standard + Marshall DSL40CR
At zero: Gain · Volume · Reverb
No effects needed for this part.
Dimebag's scooped, razor-tight Randall chug via the DSL40CR's Ultra channel OD1, bridge ProBucker full humbucker, mids pulled back with the tone-shift engaged and presence/resonance up for solid-state-style bite and tight low end.
Without the pre-amp boost the chug is less saturated and less tight/aggressive.
Workaround: Push gain_ultra to ~7.5 and attack hard with consistent palm muting; keep master up for power-amp tightness.
Riff stops ring and hiss instead of being dead silent.
Workaround: Mute with the right palm and left-hand damping on every stop; roll bridge volume down between takes.
Loses the subtle hollow whoosh in the layered rhythm sound.
Workaround: Skip it; the mid-scoop plus tone shift gives much of that hollow character.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge
Dean ML (bridge pickup) → Furman PQ-3/PQ-4 Parametric EQ → MXR Blue Six-Band EQ → Rocktron Hush 2-B noise gate → MXR Flanger (one stack only) → Randall Century 200 head → Randall 4x12 cabinet
The notes are simple, but the swung timing, hard palm-mute consistency and dead-silent stops are what make or break the riff.
Every song already dialed in for the Marshall DSL40CR.
Marshall DSL40CR settings