Pantera · settings for Epiphone Les Paul Standard + Marshall JCM800 2203
No effects needed for this part.
Dimebag's scooped solid-state razor into a JCM800: High input, preamp pushed, mids dropped, bass and treble up, presence biting. No reverb, no pedals \u2014 the Marshall's own saturation plus tight muting carries the riff.
Loses the huge front-end gain push and mid sculpting that defines the attack.
Workaround: Run High input with preamp near 9 and middle at 3 to approximate the boost and scoop.
Riff stops ring with hiss at this gain level.
Workaround: Mute with the picking hand and left-hand damping on every stop; roll guitar volume off between sections.
Loses the subtle hollow whoosh on one blended stack.
Workaround: Skip it; it was only on one of several stacks and is barely audible.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge
Dean ML (bridge pickup) → Furman PQ-3/PQ-4 Parametric EQ → MXR Blue Six-Band EQ → Rocktron Hush 2-B noise gate → MXR Flanger (one stack only) → Randall Century 200 head → Randall 4x12 cabinet
The notes are simple, but the swung timing, hard palm-mute consistency and dead-silent stops are what make or break the riff.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings