Pixies · settings for Epiphone Les Paul Standard + Line 6 Helix Floor (direct)
Decay low. Just enough to kill hiss.
Bright off.
Dynamic 57 mic, distance 1-2 in, Low Cut 90 Hz, High Cut 7 kHz.
Decay long.
Bridge humbucker into a Helix clean-edge patch: Jazz Rivet 120 for solid-state clarity, pushed slightly toward breakup, 1x12 cab, spring reverb with a long tail. No drive pedals; the edge comes from picking hard.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker (estimated from the bright, cutting lead melody)
Gibson Les Paul Goldtop, 1970s (borrowed from Kim Deal) → Peavey Special 130 solid-state 1x12 combo → Peavey Special internal 12-inch speaker (combo)
No pedals documented on this part.
Amp effects: reverb (Peavey Special combos have onboard spring reverb; Santiago says he leaned on built-in amp reverb on the early records. Some wash may also be studio/plate reverb added by Albini.)
The lead is a short, repetitive melodic figure; the challenge is clean articulation, consistent bends and letting the reverb tail breathe.
Every song already dialed in for the Line 6 Helix Floor.
Line 6 Helix Floor presets