Pixies · settings for Epiphone Les Paul Standard + Marshall JCM800 2203
No effects needed for this part.
Les Paul bridge humbucker into the JCM800's Low input with modest pre-amp for a clean, slightly edgy lead voice. The original's generous reverb is missing because the 2203 has no reverb, so a reverb pedal in the FX loop is the key purchase.
Without reverb the lead sounds dry and loses its dreamy long tail.
Workaround: Play in a live room or add reverb in your recording software.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker (estimated from the bright, cutting lead melody)
Gibson Les Paul Goldtop, 1970s (borrowed from Kim Deal) → Peavey Special 130 solid-state 1x12 combo → Peavey Special internal 12-inch speaker (combo)
No pedals documented on this part.
Amp effects: reverb (Peavey Special combos have onboard spring reverb; Santiago says he leaned on built-in amp reverb on the early records. Some wash may also be studio/plate reverb added by Albini.)
The lead is a short, repetitive melodic figure; the challenge is clean articulation, consistent bends and letting the reverb tail breathe.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings