Chris Isaak · settings for Squier Stratocaster + Marshall DSL40CR
At zero: Gain · Volume
7, Classic channel reverb.
Clean Marshall DSL40CR on Classic Gain/Clean, neck pickup, tone rolled back for warmth, amp reverb generous. Without delay or chorus, lean on volume-swell attack, vibrato-arm shimmer and the amp's spring-style reverb to carry the atmosphere.
Loses the lazy echo bloom behind each sustained note; the riff sounds dry and bare.
Workaround: Push amp reverb to 7-8 and let notes ring full value, spacing phrases wider to fake the trailing echoes.
No stereo shimmer or width; the tone sits flat and mono.
Workaround: Use wide vibrato-arm wobble on sustained notes to add movement by hand.
Note attacks have pick transient instead of a soft fade-in.
Workaround: Swell with the guitar volume knob using the pinky, or pick behind the bridge and fade in.
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Neck (or neck+middle) single-coil
Fender 1962 Stratocaster Reissue (neck pickup) → Ernie Ball volume pedal → 1964 Fender Deluxe Reverb (spring reverb up, clean) → Combo 1x12 speaker, SM57 → TC Electronic 2290 delay (console send) → Eventide H3000 Rich Chorus (stereo)
Amp effects: reverb (Blackface Deluxe Reverb spring reverb set generous (~6); core of the wet, cavernous riff tone), tremolo (Amp's vibrato circuit, slow and shallow if used; subtle at most on the record)
The notes are few and slow, but the identity lives in whammy-bar vibrato, pre-bends and restraint, which are hard to make sound convincing.
Every song already dialed in for the Marshall DSL40CR.
Marshall DSL40CR settings