Chris Isaak · settings for Squier Stratocaster + Marshall JCM800 2203
No effects needed for this part.
A JCM800 can't be a blackface Deluxe, but at low preamp through the Low input it gives a stiff, bright clean. Neck pickup, tone rolled back, master up for tube warmth. The wet ambience must come from added gear.
Without the long triplet echo bloom the riff sounds dry, short and ordinary.
Workaround: Play the hook with long sustained notes and let whammy vibrato carry the tail; record with delay added afterwards in software.
Loses the wide shimmering stereo bloom that makes the tone dreamlike.
Workaround: Use slow, deep whammy-bar vibrato on sustained notes to imitate the pitch movement.
Note attacks are picked rather than fading in, slightly harder-edged.
Workaround: Swell with the guitar volume knob using the pinky, or pick behind the bridge-side and fade in.
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Neck (or neck+middle) single-coil
Fender 1962 Stratocaster Reissue (neck pickup) → Ernie Ball volume pedal → 1964 Fender Deluxe Reverb (spring reverb up, clean) → Combo 1x12 speaker, SM57 → TC Electronic 2290 delay (console send) → Eventide H3000 Rich Chorus (stereo)
Amp effects: reverb (Blackface Deluxe Reverb spring reverb set generous (~6); core of the wet, cavernous riff tone), tremolo (Amp's vibrato circuit, slow and shallow if used; subtle at most on the record)
The notes are few and slow, but the identity lives in whammy-bar vibrato, pre-bends and restraint, which are hard to make sound convincing.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings