Alice In Chains · settings for Fender Precision Bass + Ampeg SVT-CL + 810
No effects needed for this part.
You have essentially the record's amp. Run the SVT-CL fairly hot with Ultra Hi engaged for pick clank, mids present at the 800 Hz-ish position, and let the passive P-bass drive the tube preamp to edge-of-breakup.
Loses the parallel mid-grind grit layer under the clean tone
Workaround: Push amp gain to 6.5-7 and dig in with the pick for tube breakup
Less even sustain and a less forward attack
Workaround: Consistent pick depth and the SVT's natural tube compression at higher master
Slightly narrower, less shimmering low end
Workaround: Skip it; it was blended very low and is barely audible
This page assumes a Fender Precision Bass with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Both P/J pickups, slight bridge emphasis for pick attack
Spector NS-2 (EMG P/J, active preamp) → split: Tech 21 SansAmp track → split: direct DI track → split: FX track with slight chorus/flange → Ampeg SVT head → Ampeg 8x10 cabinet (SM57 on one cone) → parallel Vox Westminster 18-inch amp
The riff is simple and repetitive; the challenge is pick consistency, note length and the aggressive attack rather than technique.