Alice In Chains · settings for Fender Precision Bass + Fender Rumble 40
No effects needed for this part.
P-Bass into the Rumble 40 with the Overdrive voicing nudged in for SVT-style grind: thick low-mids, bright treble for pick clank, volume wide open, tone rolled back slightly.
Without it the grind is amp-only and less tight; the parallel clean/dirty blend is gone.
Workaround: Use the Rumble's Overdrive at gain 6.5 and dig in hard with the pick to push grit only on attack.
Notes are less even and the riff sits less 'in your face'.
Workaround: Play with very consistent right-hand pick strength and slightly choke note lengths to fake even sustain.
Loses a subtle width/shimmer that is barely audible in the mix anyway.
Workaround: Skip it; the Rumble 40 has no modulation and the effect was blended very low.
This page assumes a Fender Precision Bass with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Both P/J pickups, slight bridge emphasis for pick attack
Spector NS-2 (EMG P/J, active preamp) → split: Tech 21 SansAmp track → split: direct DI track → split: FX track with slight chorus/flange → Ampeg SVT head → Ampeg 8x10 cabinet (SM57 on one cone) → parallel Vox Westminster 18-inch amp
The riff is simple and repetitive; the challenge is pick consistency, note length and the aggressive attack rather than technique.