Yorushika · settings for Squier Stratocaster + Blackstar ID:Core 20 V3
Feedback low (2-3 repeats), level about 30%.
Room/plate type, level ~25%, short-medium decay.
Edge-of-breakup Telecaster lead reimagined on a Squier Strat into the ID:Core's Crunch voice, ISF pushed British for midrange. Built-in delay and reverb cover the ambient repeats; no compressor or overdrive available, so volume and picking do the sustain work.
Less midrange push and sustain lift for the solo; notes decay faster.
Workaround: Use Crunch mode with ISF at 6.5 and full guitar volume; pick harder to drive the front end.
Sustain is less even and bloom on single-note lines is reduced.
Workaround: Compress by hand: consistent medium pick attack and continuous vibrato to hold notes.
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge pickup (bridge+neck middle position also plausible for the softer phrases)
Fender Telecaster → Orange Kongpressor → Overdrive (Tube Screamer / Blues Driver type) → Digital/analog delay → Walrus Audio SLO reverb → Fender Harvard-style combo amp → Combo internal speaker
Moderate: the notes are not extreme, but phrasing, clean articulation and delay-aware timing carry the part.
Every song already dialed in for the Blackstar ID:Core 20 V3.
Blackstar ID:Core 20 V3 settings