Yorushika · settings for Squier Stratocaster + Marshall JCM800 2203
No effects needed for this part.
A JCM800 can't be a small Fender clean combo, but the Low input with modest pre-amp gives a mid-forward edge-of-breakup lead. Bridge-plus-middle Strat position tames ceramic brightness; no pedals means the delay/reverb wash is absent.
Loses the signature spacious quarter-note lead repeats that define the solo's rhythm.
Workaround: Play slightly behind the beat and let notes ring; sustain bends to fake the tail.
No ambient wash behind the lead; tone sounds dry and close.
Workaround: Use the room; stand off-axis from the cab and let long notes bloom.
Less even sustain and bloom on single-note lines.
Workaround: Pick consistently and use vibrato to sustain; the cranked power section compresses somewhat.
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge pickup (bridge+neck middle position also plausible for the softer phrases)
Fender Telecaster → Orange Kongpressor → Overdrive (Tube Screamer / Blues Driver type) → Digital/analog delay → Walrus Audio SLO reverb → Fender Harvard-style combo amp → Combo internal speaker
Moderate: the notes are not extreme, but phrasing, clean articulation and delay-aware timing carry the part.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings