Korn · settings for Epiphone Les Paul Standard + Line 6 Helix Floor (direct)
Decay 30% for stop-start silence.
Parked ~60% toe-down, Mix 100%. On for intro figure only.
Tightens low end.
Mix ~40% as a thickening layer.
Ch Vol unity.
57 Dynamic, 1-2 in, 25% off-axis, Low Cut 80Hz, High Cut 7kHz.
Decay short — studio room only.
Helix direct, Cali Rectifire into a 4x12 IR for the Recto chug. Scream 808 up front as a tight boost, Triangle Fuzz as the thickening layer, cocked Vintage Wah for the intro figure. Bridge ProBucker, tone rolled slightly back.
Quiet clean figures sound narrower than the record.
Workaround: Add a Chorus block after the amp set low rate/depth, engaged only on clean passages.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker
Ibanez Universe UV7 (bridge humbucker) → Dunlop Cry Baby wah → Ibanez TS9 Tube Screamer → Electro-Harmonix Big Muff Pi → Ibanez BC-9 Bi-Mode Chorus → Mesa/Boogie Dual Rectifier head → Mesa/Boogie 4x12 cabinet
The notes are simple two-finger power-chord shapes, but the groove, mute control and the quiet-to-loud dynamic swing carry the part.
Every song already dialed in for the Line 6 Helix Floor.
Line 6 Helix Floor presets