Korn · settings for Epiphone Les Paul Standard + Marshall DSL40CR
At zero: Gain · Volume · Reverb
No effects needed for this part.
Ultra Gain OD2 on the DSL with scooped mids and heavy low end gets close to the Recto chug. No Tube Screamer or Muff, so lean on bridge humbucker, tight palm muting and the tone-shift scoop.
Low end is looser and the riff less focused without the front-end boost.
Workaround: Trim bass to ~7 and keep gain at 7.5 so the amp stays tight; mute hard at the bridge.
Less compressed thickness on the detuned layers.
Workaround: Push gain_ultra to 8 and pick lighter for a compressed feel.
No nasal cocked-wah honk on the intro figure accents.
Workaround: Roll bridge tone to ~5 and pick near the neck for a hollower voice.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker
Ibanez Universe UV7 (bridge humbucker) → Dunlop Cry Baby wah → Ibanez TS9 Tube Screamer → Electro-Harmonix Big Muff Pi → Ibanez BC-9 Bi-Mode Chorus → Mesa/Boogie Dual Rectifier head → Mesa/Boogie 4x12 cabinet
The notes are simple two-finger power-chord shapes, but the groove, mute control and the quiet-to-loud dynamic swing carry the part.
Every song already dialed in for the Marshall DSL40CR.
Marshall DSL40CR settings