The Smashing Pumpkins · settings for Squier Stratocaster + Line 6 POD Go (direct)
Sustain max, Tone 60%, Volume to unity.
Level unity - tightens the low end.
Master high.
Mic SM57, distance low, high cut ~8kHz, low cut ~90Hz.
-3dB at 600Hz, +2dB at 100Hz, gentle 7kHz shelf cut.
Decay short, Pre-delay 20ms.
POD Go direct: Triangle Fuzz into Brit 2204 for the op-amp Muff wall, plus a Classic Distortion stacked for tightness, EQ to tame ceramic brightness, and a short plate reverb standing in for the studio room.
Triangle Fuzz is a brighter, less mid-scooped voice than an op-amp Muff, so the wall is slightly thinner.
Workaround: Max Triangle Fuzz sustain and cut 400-800Hz with the EQ block to fake the op-amp mid scoop.
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge (neck single-coil on some of the layered tracks)
Fender Stratocaster (Lace Sensors) → Electro-Harmonix op-amp Big Muff Pi → MXR Distortion II → Marshall 100W head, low-sensitivity input → Marshall 4x12 cabinet → SM57 close mic
Notes are simple, but the groove relies on precise palm muting of the low E between octave hits, and the recorded size comes from multi-tracking rather than one pass.