The Smashing Pumpkins · settings for Squier Stratocaster + Marshall JCM800 2203
No effects needed for this part.
You have the actual JCM800 2203. Run it Corgan-style: Low input, master wide open, preamp barely on. The missing piece is an op-amp Big Muff, so the amp alone must supply the grit \u2014 push preamp higher than the original until you get a fuzz pedal.
Without it you lose the scooped, compressed wall-of-fuzz sustain that defines the riff.
Workaround: Crank the preamp to 7-8 into the Low input and dip Middle to ~4.5 for a pseudo-scooped saturation; let power-amp compression do the sustain.
Loses a little tightness and edge stacked under the fuzz.
Workaround: Higher preamp setting plus Presence at 6 recovers the tight attack.
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge (neck single-coil on some of the layered tracks)
Fender Stratocaster (Lace Sensors) → Electro-Harmonix op-amp Big Muff Pi → MXR Distortion II → Marshall 100W head, low-sensitivity input → Marshall 4x12 cabinet → SM57 close mic
Notes are simple, but the groove relies on precise palm muting of the low E between octave hits, and the recorded size comes from multi-tracking rather than one pass.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings