The Smashing Pumpkins · settings for Squier Stratocaster + Marshall MG30GFX
At zero: FX Level · Reverb
No effects needed for this part.
No fuzz pedal, so the MG30's OD2 channel carries the wall-of-fuzz duty. Bridge pickup, bright ceramic singles tamed slightly with the tone knob, mids left mid-ish, reverb off. Expect a tighter, smaller distortion than eight stacked op-amp Muffs.
Without the op-amp Muff you lose the mid-scooped, compressed sustain and sheer size of the riff.
Workaround: Max the OD2 gain and roll the guitar tone to ~7 to imitate the Muff's soft, saturated top end.
Loses a bit of tightness and extra bite stacked under the fuzz.
Workaround: The OD2 channel's own preamp distortion supplies that tightening role.
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge (neck single-coil on some of the layered tracks)
Fender Stratocaster (Lace Sensors) → Electro-Harmonix op-amp Big Muff Pi → MXR Distortion II → Marshall 100W head, low-sensitivity input → Marshall 4x12 cabinet → SM57 close mic
Notes are simple, but the groove relies on precise palm muting of the low E between octave hits, and the recorded size comes from multi-tracking rather than one pass.
Every song already dialed in for the Marshall MG30GFX.
Marshall MG30GFX settings