Pantera · settings for Squier Stratocaster + Fender Mustang GTX50
Mid-hump type.
Light: sustain 3, level matched.
Rate very slow, depth low, feedback low, mix ~40%.
Small room, level 1.5.
Dimebag's razor high-gain solo tone adapted for a Squier Strat into a Mustang GTX50 using the Metal 2000 voicing, bridge pickup, extra gain to compensate for low-output single-coils, plus a built-in overdrive/EQ-style mid push and subtle flanger doubling.
Without the frown-curve boost the tone loses upper-mid cut and preamp saturation.
Workaround: Use the built-in overdrive at low drive/high level plus Middle 6.5 to fake the 800Hz-1.6kHz push.
High gain into single-coils will hum and ring between fast phrases.
Workaround: Mute with the picking-hand palm and roll guitar volume down between phrases; angle away from the amp.
Some solo runs lose the two-guitar unison-detune thickness.
Workaround: Lean on the flanger doubler block for width instead.
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker (Bill Lawrence L-500XL)
Dean ML (Bill Lawrence L-500XL bridge) → Dunlop Cry Baby wah → MXR Six Band Graphic EQ → Furman PQ-3 Parametric EQ → Noise gate (Boss/Rocktron Hush) → Randall RG100ES head → MXR Flanger/Doubler (effects loop) → Randall 4x12 cabinet
The solo mixes rapid picked lines, aggressive bends and Floyd Rose dives with Dime's signature harmonic squeals, demanding clean right-hand muting at high gain.
Every song already dialed in for the Fender Mustang GTX50.
Fender Mustang GTX50 settings