Pantera · settings for Squier Stratocaster + Marshall CODE 25
Placed before the amp model.
Low amount, ~3.
Speed slow, depth low, feedback low, mix ~25%.
Dimebag's razor high-gain Randall lead tone on a CODE 25: JCM800 model with the built-in distortion pedal stacked in front to make up for low-output single-coils, mids pushed for the upper-mid bite, noise managed with the compressor and right-hand muting.
Without the mid 'frown' boost the tone loses cut and preamp saturation.
Workaround: Use the amp's distortion block as a mid-pushing boost and keep Middle around 6.
Single-coils at this gain will hiss and hum between phrases.
Workaround: Mute with the picking hand palm and left-hand damping; angle away from the amp to kill hum.
Some solo runs lose the doubled, two-guitar width.
Workaround: The flanger set as a doubler gives some width; otherwise play the runs single.
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker (Bill Lawrence L-500XL)
Dean ML (Bill Lawrence L-500XL bridge) → Dunlop Cry Baby wah → MXR Six Band Graphic EQ → Furman PQ-3 Parametric EQ → Noise gate (Boss/Rocktron Hush) → Randall RG100ES head → MXR Flanger/Doubler (effects loop) → Randall 4x12 cabinet
The solo mixes rapid picked lines, aggressive bends and Floyd Rose dives with Dime's signature harmonic squeals, demanding clean right-hand muting at high gain.
Every song already dialed in for the Marshall CODE 25.
Marshall CODE 25 settings