Pantera · settings for Squier Stratocaster + Marshall JCM800 2203
No effects needed for this part.
Dime's Randall solid-state ultra-gain through a Squier Strat and JCM800: run the High input with the pre-amp maxed, bridge single-coil, and a hard upper-mid push from the Middle and Presence knobs to fake the stacked EQ boost.
Without it the JCM800 lacks the extra preamp push and the cutting 800Hz-1.6kHz frown that defines Dime's lead.
Workaround: Max the pre-amp on the High input and push Middle/Presence up; pick harder near the bridge for attack.
Maxed preamp with single-coils will hiss and hum badly between phrases.
Workaround: Mute with the picking hand palm and roll the guitar volume down between lead phrases; angle away from the amp.
Leads sound thinner and less 'two-guitar' wide than the record.
Workaround: Use vibrato and wide bends for movement; no built-in modulation on this amp.
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker (Bill Lawrence L-500XL)
Dean ML (Bill Lawrence L-500XL bridge) → Dunlop Cry Baby wah → MXR Six Band Graphic EQ → Furman PQ-3 Parametric EQ → Noise gate (Boss/Rocktron Hush) → Randall RG100ES head → MXR Flanger/Doubler (effects loop) → Randall 4x12 cabinet
The solo mixes rapid picked lines, aggressive bends and Floyd Rose dives with Dime's signature harmonic squeals, demanding clean right-hand muting at high gain.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings