Ozzy Osbourne · settings for Epiphone Les Paul Standard + Marshall DSL40CR
At zero: Gain · Volume · Reverb
No effects needed for this part.
DSL40CR Classic channel in Crunch gets close to a nearly-clean Super Lead pushed by a Distortion+. Bridge ProBucker, mids cranked for the 500Hz push, lean bass, bright treble. Medium crunch, not saturated, so pick attack stays articulate.
Loses the slightly compressed, grainy germanium-ish edge on the riff attack.
Workaround: Use Crunch mode with gain near 7.5 and keep master up so the power tubes compress.
Less of the sharply focused 500Hz honk and level boost that make the riff cut.
Workaround: Middle at 8 with bass pulled back approximates the mid hump; leave the tone shift button out.
Rhythm sits narrower and drier than the wide doubled record image.
Workaround: Skip it live; it was a mix effect, not part of the player's sound.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
1974 Gibson Les Paul Custom (bridge pickup) → MXR Distortion + → MXR Ten Band Graphic EQ → Marshall JMP 1959 Super Lead MKII 100W → Marshall 1960A 4x12 cabs (Altec speakers) → AMS DMX 15-80S short delay/detune (console, rhythm tracks)
The main riff is a moderate-tempo single-note line that is easy to learn but demands clean picking, steady timing and consistent muting to sound right.
Every song already dialed in for the Marshall DSL40CR.
Marshall DSL40CR settings