Ozzy Osbourne · settings for Epiphone Les Paul Standard + Marshall JCM800 2203
No effects needed for this part.
The JCM800 has far more preamp gain than Randy's nearly-clean Super Lead, so dial a medium crunch with pushed mids instead of stacking drive. Bridge ProBucker, tone wide open, mids up for the 500Hz push.
Loses the slightly fizzy, mid-pushed pedal-into-clean-amp grit; the JCM800 preamp is tighter and darker.
Workaround: Use the High input with preamp around 5 for the same crunch level, middle up to mimic the pedal's mid hump.
No dedicated 500Hz/1k push or level boost, so the riff cuts less in a mix.
Workaround: Middle at 8 and treble at 7 on the amp approximate the mid-forward curve.
Rhythm image stays mono and narrower than the record.
Workaround: Double-track the riff yourself if recording; live, play it dry as Rhoads did.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
1974 Gibson Les Paul Custom (bridge pickup) → MXR Distortion + → MXR Ten Band Graphic EQ → Marshall JMP 1959 Super Lead MKII 100W → Marshall 1960A 4x12 cabs (Altec speakers) → AMS DMX 15-80S short delay/detune (console, rhythm tracks)
The main riff is a moderate-tempo single-note line that is easy to learn but demands clean picking, steady timing and consistent muting to sound right.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings