Ozzy Osbourne · settings for Epiphone Les Paul Standard + Yamaha THR10II
Feedback minimum, low mix via Echo/Reverb at 2.
Randy's nearly-clean Super Lead plus Distortion+ becomes the THR10II's Crunch voicing with mids pushed hard. Bridge ProBucker, both guitar knobs wide open, lean bass, bright treble, and a touch of short delay to hint at the doubled studio rhythm image.
Loses the sharp 500Hz spike and level boost that make the riff cut.
Workaround: Push Middle to 8-9 and keep Bass low to emulate the midrange hump.
Amp gain alone is slightly softer and less grainy than the hard-clipped MXR.
Workaround: Crunch mode gain near 6.5 with bridge humbucker gets close in saturation level.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
1974 Gibson Les Paul Custom (bridge pickup) → MXR Distortion + → MXR Ten Band Graphic EQ → Marshall JMP 1959 Super Lead MKII 100W → Marshall 1960A 4x12 cabs (Altec speakers) → AMS DMX 15-80S short delay/detune (console, rhythm tracks)
The main riff is a moderate-tempo single-note line that is easy to learn but demands clean picking, steady timing and consistent muting to sound right.