Architects · settings for Epiphone Les Paul Standard + Blackstar ID:Core 20 V3
No effects needed for this part.
Architects' tight 6505+ chug on a 20W Blackstar: OD2 voice, gain high but controlled, ISF toward American for scooped mids, bridge ProBucker full up. No drive or gate pedals, so pick-hand muting does the tightening.
Without a low-gain boost the chugs lose their tight, filtered attack and sound looser.
Workaround: Roll bass back to about 4.5 and keep amp gain just below where it mushes; mute hard at the bridge.
Gaps between staccato chugs ring and hiss instead of going dead silent.
Workaround: Choke strings with the palm and fretting-hand fingers at the end of each chug.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
ESP LTD baritone-style guitar (EverTune) → Noise gate → Maxon OD-808 → Peavey 6505+ head → Oversized Mesa/Boogie 4x12 with Vintage 30s → SM57 (Kemper profile used for the final tone)
The notes are simple, but the riff lives or dies on muting precision and timing at a very low tuning.
Every song already dialed in for the Blackstar ID:Core 20 V3.
Blackstar ID:Core 20 V3 settings