Architects · settings for Epiphone Les Paul Standard + Marshall DSL40CR
At zero: Gain · Volume · Reverb
No effects needed for this part.
Ultra Gain OD1 on the DSL40CR with mids pulled way back and presence/resonance up gets close to the 6505+ chug. ProBuckers are lower output than actives, so gain goes a bit higher and palm-mute discipline carries the rest.
Without a low-end-filtering boost the chugs lose tightness and get woolly in drop tuning.
Workaround: Lower Bass to 4, raise Presence slightly and mute very tightly at the bridge; keep Master up so the power section tightens.
High-gain stop-start chugs ring and hiss in the gaps, blurring the syncopation.
Workaround: Mute with the palm and fretting-hand fingers on every rest; roll bridge volume back between phrases.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
ESP LTD baritone-style guitar (EverTune) → Noise gate → Maxon OD-808 → Peavey 6505+ head → Oversized Mesa/Boogie 4x12 with Vintage 30s → SM57 (Kemper profile used for the final tone)
The notes are simple, but the riff lives or dies on muting precision and timing at a very low tuning.
Every song already dialed in for the Marshall DSL40CR.
Marshall DSL40CR settings