Architects · settings for Epiphone Les Paul Standard + Marshall MG30GFX
At zero: FX Level · Reverb
No effects needed for this part.
Modern metalcore chug from a 30W solid-state Marshall: OD2 channel, tight low end, scooped mids, bright bite. Bridge humbucker, everything wide open, no reverb. Lack of a tightening overdrive and gate is the main compromise.
Without it the low end is looser and less focused; chugs lose their percussive snap.
Workaround: Lower amp bass to ~4 and gain to ~6.5, pick nearer the bridge and mute hard to fake the tightening.
Gaps between staccato chugs ring and hiss instead of snapping silent.
Workaround: Mute with the picking-hand palm and left-hand fingers immediately after each chug; back guitar volume off between phrases.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
ESP LTD baritone-style guitar (EverTune) → Noise gate → Maxon OD-808 → Peavey 6505+ head → Oversized Mesa/Boogie 4x12 with Vintage 30s → SM57 (Kemper profile used for the final tone)
The notes are simple, but the riff lives or dies on muting precision and timing at a very low tuning.
Every song already dialed in for the Marshall MG30GFX.
Marshall MG30GFX settings