Metallica · settings for Epiphone Les Paul Standard + Blackstar ID:Core 20 V3
No effects needed for this part.
Metallica's scooped high-gain chug on an ID:Core 20: OD2 voice, bridge ProBucker full up, ISF toward American for the mid-scoop, gain just under max, no ambience. Tight and dry; the 20W speaker limits low-end thump.
Without the 1.2kHz cut the riff sounds honkier and less scooped than the record.
Workaround: Lower ISF to 2-3 and keep treble high; roll bridge tone to ~8 if the upper mids honk.
Palm-mute tails are less gated, so high-gain hiss and string noise linger.
Workaround: Mute with the picking-hand heel and left-hand fingers; keep gain at 7.5 rather than maxed.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker (EMG 81)
ESP Explorer-style guitar (EMG 81, bridge) → Mesa/Boogie Mark IIC++ preamp → Aphex EQF-2 EQ (loop) → Aphex CX-1 compressor (loop) → Mark IIC++ power amp / blended Jose-modded Marshall → Marshall 4x12 cabinets → Eventide H3000 (mix-stage widening)
The notes are simple, but the signature sound depends on even palm-mute pressure, precise downstrokes and clean string muting at high gain.
Every song already dialed in for the Blackstar ID:Core 20 V3.
Blackstar ID:Core 20 V3 settings