Metallica · settings for Epiphone Les Paul Standard + Marshall DSL40CR
At zero: Gain · Volume · Reverb
No effects needed for this part.
Ultra Gain OD1 on the DSL40CR with the tone shift engaged gets close to the scooped Mesa chug. Bridge ProBucker full up, dry and tight, no reverb. Palm-mute control does the rest.
Without the 1.2kHz cut the riff sounds boxier and less tight than the record.
Workaround: Engage the tone shift button and keep middle near 3 to approximate the scoop.
Palm-mute tails ring on slightly longer and noise floor is higher.
Workaround: Mute with the picking-hand palm and left-hand fingers; keep gain moderate.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker (EMG 81)
ESP Explorer-style guitar (EMG 81, bridge) → Mesa/Boogie Mark IIC++ preamp → Aphex EQF-2 EQ (loop) → Aphex CX-1 compressor (loop) → Mark IIC++ power amp / blended Jose-modded Marshall → Marshall 4x12 cabinets → Eventide H3000 (mix-stage widening)
The notes are simple, but the signature sound depends on even palm-mute pressure, precise downstrokes and clean string muting at high gain.
Every song already dialed in for the Marshall DSL40CR.
Marshall DSL40CR settings