Metallica · settings for Epiphone Les Paul Standard + Fender '65 Twin Reverb Reissue
At zero: Bright switch · Reverb · Tremolo Speed · Tremolo Intensity
No effects needed for this part.
A Twin Reverb with no drive pedals cannot make Mesa high gain. Dial the loudest, darkest, most mid-scooped clean the amp allows, hit the bridge ProBucker hard, and accept an overdriven-clean chug. A distortion pedal is essential for this riff.
Without it the riff is a clean chug with no saturation, sustain or percussive crunch.
Workaround: Volume at 7+ with bridge humbucker gives mild power-tube breakup; dig in hard with downstrokes for fake grit.
Loses the 1.2kHz cut that tightens the riff and removes honk.
Workaround: Set amp middle to 2 and roll guitar tone to about 8 to approximate the cut.
Palm-mute tails ring on and noise is less controlled between chugs.
Workaround: Mute with the picking-hand palm and left-hand fingers for hard stops.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker (EMG 81)
ESP Explorer-style guitar (EMG 81, bridge) → Mesa/Boogie Mark IIC++ preamp → Aphex EQF-2 EQ (loop) → Aphex CX-1 compressor (loop) → Mark IIC++ power amp / blended Jose-modded Marshall → Marshall 4x12 cabinets → Eventide H3000 (mix-stage widening)
The notes are simple, but the signature sound depends on even palm-mute pressure, precise downstrokes and clean string muting at high gain.
Every song already dialed in for the Fender '65 Twin Reverb Reissue.
Fender '65 Twin Reverb Reissue settings