Avenged Sevenfold · settings for Squier Stratocaster + Blackstar ID:Core 20 V3
Digital/linear type, ~400 ms, feedback low (2-3 repeats), level ~20%.
OD2 voice with British-leaning ISF gets the closest high-gain lead voicing from the ID:Core 20. Low-output single-coils need more gain and brightness control; add short digital delay for the solo's ambience. No Whammy or pedal distortion available.
Without it the amp alone gives less note compression and sustain for sweeps and legato.
Workaround: Push OD2 gain to 8.5 and pick harder; roll guitar volume back slightly to clean up chords.
Octave-up squeals and pitch dives in the lead section cannot be reproduced.
Workaround: Play the octave-up accents on high frets and use bends/vibrato for the dive gestures.
Less mid lift and low cut to push the lead above a dense mix.
Workaround: ISF at 7 plus bass at 3.5 approximates the low cut and 800 Hz push.
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker (Invader) for the solo
Schecter Synyster Gates Custom-S (bridge Invader) → Original Syn distortion → DigiTech Whammy → Graphic EQ → Schecter Hellwin USA 100 head → Digital delay (rack/post) → 4x12 cabinet
A typical Synyster Gates lead: quick sweeps, legato runs and jazz-tinged note choices at a brisk tempo, demanding clean right-hand sync and muting.
Every song already dialed in for the Blackstar ID:Core 20 V3.
Blackstar ID:Core 20 V3 settings