Avenged Sevenfold · settings for Squier Stratocaster + Vox AC30C2
At zero: Volume · Tremolo Speed · Tremolo Depth
An AC30 with no pedals and low-output single-coils can't reach Hellwin-grade high gain, so we push the Top Boost channel into its loudest natural crunch for a mid-forward, sustaining lead voice and accept less saturation and tighter note separation than the record.
Without it the AC30 only crunches; fast sweeps and legato lose sustain and compression.
Workaround: Crank Top Boost volume to 9+, pick hard and use vibrato to sustain; keep lines in the upper register.
Lead sits dry and small without the dotted-eighth repeats behind it.
Workaround: Use amp reverb at 2 in place of repeats; the amp's FX loop is ready if you add a delay.
Less lead lift above a dense mix.
Workaround: Tone Cut at 4 with bass 6 approximates the low trim and mid emphasis.
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Bridge humbucker (Invader) for the solo
Schecter Synyster Gates Custom-S (bridge Invader) → Original Syn distortion → DigiTech Whammy → Graphic EQ → Schecter Hellwin USA 100 head → Digital delay (rack/post) → 4x12 cabinet
A typical Synyster Gates lead: quick sweeps, legato runs and jazz-tinged note choices at a brisk tempo, demanding clean right-hand sync and muting.