John Mayer · settings for Squier Stratocaster + Marshall DSL40CR
At zero: Gain · Volume
Classic Gain channel in Crunch mode, just at the edge of breakup, with mids pushed and presence tamed to offset the Squier's bright ceramic single-coils. Amp reverb low; the Klon push and analog delay are covered by picking dynamics and guitar volume.
Less thickness and mid push; notes may sound thinner on hard picking.
Workaround: Use Crunch mode gain 4.5 with guitar volume at 8 and dig in harder for the grit.
Riff and fills lose a small tail of depth; still sits fine dry.
Workaround: Nudge amp reverb up to 4 for a touch more ambience in place of the short delay.
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Middle single-coil
Fender Black1 Stratocaster (middle pickup) → Klon Centaur → Analog delay → Two-Rock Custom Reverb Signature (with amp reverb) → Two-Rock 2x12 cabinet
Amp effects: reverb (The Two-Rock Custom Reverb Signature has onboard tube-driven reverb; a small amount suits the track's ambience, though studio plate/room reverb was likely added in the mix.)
The riff itself is intermediate, but the tone depends on picking dynamics and precise bend/vibrato control; any sloppiness is obvious at this low gain level.
Every song already dialed in for the Marshall DSL40CR.
Marshall DSL40CR settings