John Mayer · settings for Squier Stratocaster + Marshall JCM800 2203
No effects needed for this part.
A JCM800 can't be a Two-Rock, but the Low input with modest preamp gain and bright controls dialed back gets a warm, edge-of-breakup Strat voice. Middle pickup, guitar volume at 8, tone rolled slightly for the glassy riff.
Without a low-gain boost the riff loses thickness and bloom when you dig in.
Workaround: Raise preamp to 6-6.5 and play harder; guitar volume at 8 keeps it just clean.
Fills lose a touch of depth and tail.
Workaround: Let notes ring and use the room; keep phrasing legato for sustain.
Tone is drier and more upfront than the record.
Workaround: Play in a live-sounding room; lean on sustain and vibrato.
This page assumes a Squier Stratocaster with no pedals. Adapt it to your exact rig, pedals included.
Pickup: Middle single-coil
Fender Black1 Stratocaster (middle pickup) → Klon Centaur → Analog delay → Two-Rock Custom Reverb Signature (with amp reverb) → Two-Rock 2x12 cabinet
Amp effects: reverb (The Two-Rock Custom Reverb Signature has onboard tube-driven reverb; a small amount suits the track's ambience, though studio plate/room reverb was likely added in the mix.)
The riff itself is intermediate, but the tone depends on picking dynamics and precise bend/vibrato control; any sloppiness is obvious at this low gain level.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings