Tame Impala · settings for Fender Precision Bass + Ampeg SVT-CL + 810
At zero: Ultra Lo · Ultra Hi
No effects needed for this part.
P-Bass straight into the SVT-CL, clean and loud. Dial warm low-mids, roll off highs, and let the tube preamp add light saturation. Foam mute or palm muting gives the Motown-style short thump; the amp's headroom replaces studio compression.
Notes are less even and lack the sustained, glued Motown punch.
Workaround: Push gain into the SVT preamp and play with very consistent right-hand attack for natural tube compression.
Low end is slightly narrower and drier than the record.
Workaround: Skip it live; the 810 cab's room bloom gives some width.
This page assumes a Fender Precision Bass with no pedals. Adapt it to your exact rig, pedals included.
Pickup: P-Bass split-coil (single pickup), played with pick or fingers near the bridge mute
Fender Precision Bass (foam mute) → dbx 560A compressor → Reverb → Acme Audio Motown DI WB-3 → Console / DAW (no amp or cab)
Tabbed as intermediate; the notes are not hard, but nailing the damped, evenly compressed groove and the pocket is the real work.