Tame Impala · settings for Fender Precision Bass + Darkglass Microtubes 500
At zero: Drive · Blend · Level
No effects needed for this part.
Clean, compressed P-Bass thump. Run the Darkglass in Clean voicing with drive blended out, flat-to-warm EQ, tone rolled back and foam mute at the bridge for short Motown decay.
Notes breathe unevenly; less sustain and punch than the glued studio riff.
Workaround: Play with very even right-hand attack and add foam mute under the strings to self-limit decay.
Low end is drier and narrower than the record's subtly washed bass.
Workaround: Leave it dry live; add a short plate at 10-15 percent wet in the DAW when recording.
Less transformer grit and tube-ish thickness on the DI signal.
Workaround: Nudge amp gain to 5 for a hint of input warmth and use the head's DI out.
This page assumes a Fender Precision Bass with no pedals. Adapt it to your exact rig, pedals included.
Pickup: P-Bass split-coil (single pickup), played with pick or fingers near the bridge mute
Fender Precision Bass (foam mute) → dbx 560A compressor → Reverb → Acme Audio Motown DI WB-3 → Console / DAW (no amp or cab)
Tabbed as intermediate; the notes are not hard, but nailing the damped, evenly compressed groove and the pocket is the real work.