Pink Floyd · settings for Epiphone Les Paul Standard + Blackstar ID:Core 20 V3
1-2 repeats, level low (approx 25%).
Room/plate, very low level.
Gilmour's fuzz lead on the ID:Core 20: OD2 voice pushed hard for saturated sustain, bridge ProBucker coil-split for Strat-ish bite, British-leaning ISF for mid-forward Hiwatt character, plus short delay for Echorec slapback.
Amp OD2 gives saturation but lacks the fuzz's bloom and feedback-edge sustain
Workaround: Max gain in OD2, guitar volume full, play near the amp for controlled feedback
Less push and treble lift into the amp front end
Workaround: Nudge amp gain and treble up slightly instead
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge
1969 Fender Stratocaster "Black Strat" (bridge pickup) → Dallas Arbiter Fuzz Face (silicon) → Colorsound Power Boost → Binson Echorec → Hiwatt Custom 100 DR103 → WEM 4x12 (Fane Crescendo)
Notes are not fast, but the solo lives or dies on in-tune full/compound bends, patient phrasing over the F#m-A-E and D-A changes, and controlled feedback-edge sustain.
Every song already dialed in for the Blackstar ID:Core 20 V3.
Blackstar ID:Core 20 V3 settings