Pink Floyd · settings for Epiphone Les Paul Standard + Marshall JCM800 2203
No effects needed for this part.
Gilmour's fuzz lead on a JCM800 and a Les Paul: bridge pickup, coil-split for single-coil bite, High input with the preamp pushed hard for sustain. No fuzz or echo on hand, so it lands as thick amp saturation rather than Fuzz Face bloom.
Loses the singing, compressed fuzz sustain and feedback-edge bloom that defines the solo.
Workaround: Run the High input with preamp 8.5 and play near the speaker for sustain; split coils to keep the bite.
Solo sounds dry and flat without the short drum-echo depth.
Workaround: Play slightly behind the beat and let notes ring in a live-sounding room.
Slightly less push and level into the amp for the biggest bends.
Workaround: Preamp at 8.5 already supplies the extra drive; use guitar volume to back off.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge
1969 Fender Stratocaster "Black Strat" (bridge pickup) → Dallas Arbiter Fuzz Face (silicon) → Colorsound Power Boost → Binson Echorec → Hiwatt Custom 100 DR103 → WEM 4x12 (Fane Crescendo)
Notes are not fast, but the solo lives or dies on in-tune full/compound bends, patient phrasing over the F#m-A-E and D-A changes, and controlled feedback-edge sustain.
Every song already dialed in for the Marshall JCM800 2203.
Marshall JCM800 2203 settings