Pink Floyd · settings for Epiphone Les Paul Standard + Yamaha THR10II
Feedback low (1-2 repeats), level ~30%.
No fuzz pedal, so the THR10II's Hi Gain mode plus a split bridge ProBucker gets the closest singing, saturated lead sustain. Short delay from the built-in echo stands in for the Binson Echorec. Bright, vocal, sustaining, not quite true fuzz.
Amp gain sustains but lacks the ragged, splatty fuzz edge and bloom.
Workaround: Run Hi Gain high with the bridge coil split and dig in hard for feedback-edge sustain.
Less midrange push and level lift into the amp front end.
Workaround: Raise Middle and amp gain slightly for the loudest phrases.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge
1969 Fender Stratocaster "Black Strat" (bridge pickup) → Dallas Arbiter Fuzz Face (silicon) → Colorsound Power Boost → Binson Echorec → Hiwatt Custom 100 DR103 → WEM 4x12 (Fane Crescendo)
Notes are not fast, but the solo lives or dies on in-tune full/compound bends, patient phrasing over the F#m-A-E and D-A changes, and controlled feedback-edge sustain.