Mastodon · settings for Epiphone Les Paul Standard + Blackstar ID:Core 20 V3
No effects needed for this part.
Bridge ProBucker into OD1 with ISF leaning British for a mid-forward, non-scooped JCM800-style roar. Tighten the bass and run dry. Tune to D standard. A 20W modeler gives the saturation character but not the cranked 6550 stack push.
Less tightened low end and mid push into the gain stage.
Workaround: Use OD1 with slightly less bass and higher ISF to mimic a boosted, tight front end.
This page assumes a Epiphone Les Paul Standard with no pedals. Adapt it to your exact rig, pedals included.
Pickup: bridge humbucker
Gibson Les Paul Custom (1982) → BK Butler Tube Driver → Marshall JCM800 2203 100W, modded to 6550 power tubes → Marshall 4x12 (model not documented)
Riff itself is a short repeating figure, but the speed, triplet feel and consistent palm-mute attack take practice to lock in with the drums.
Every song already dialed in for the Blackstar ID:Core 20 V3.
Blackstar ID:Core 20 V3 settings